How Much Does New Siding Cost in Colorado?

The Short Answer: Typical Cost Ranges by Material

Across the Front Range, an installed siding project (materials plus labor) generally falls into these relative tiers. These are planning brackets that vary widely by home, not quotes:

• Vinyl: generally the most budget-friendly option per square foot installed.
• Engineered wood: typically mid-range, sitting above vinyl and often below or near fiber-cement.
• Fiber-cement: usually the priciest of the three installed, reflecting heavier material and more labor-intensive installation.

For a whole-home re-side, the total swings a lot with square footage. A modest single-story ranch and a large two-story home with complex angles can differ substantially using the exact same product. That is why we measure before we quote.

What Actually Drives the Price

Material choice is only one lever. Several other factors often matter just as much, and they are the reason two homes on the same street can get very different numbers:

• Square footage and home shape: more wall area costs more, and lots of corners, gables, and windows add cutting and labor.
• Tear-off and disposal: removing old siding (and hauling it) adds cost, especially if there are multiple layers or older materials underneath.
• Trim, fascia, and soffit: wrapping or replacing trim is often a meaningful line item that people forget when comparing bids.
• Prep and repairs: rotted sheathing, moisture barrier, or insulation work discovered during tear-off can change the scope.
• Access and height: two- and three-story walls, steep grades, and tight lots take more time and equipment.

When you compare quotes, make sure each one covers the same scope. A lower bid that excludes tear-off, trim, or a new weather-resistive barrier is not really lower.

Why Colorado Conditions Change the Math

Front Range weather is hard on exteriors, and that should factor into both the product you pick and what you budget. We see a few stressors repeatedly:

Hail and wind: Colorado is among the more hail-prone parts of the country, and strong wind events are common. Impact resistance and proper fastening matter here more than in milder climates. High-altitude UV: intense sun can fade and degrade some finishes faster, so factory finishes and warranties are worth weighing. Freeze-thaw cycles: moisture that gets behind siding and then freezes can cause damage over time, which is why flashing, the weather barrier, and clean detailing are not places to cut corners.

None of this means one material is automatically right for you. It means the install quality and the details often matter as much as the brand on the box.

Energy and Durability Tradeoffs

Cheaper upfront does not always mean cheaper over the life of the home. Here is the honest tradeoff picture for the three materials:

• Vinyl: lowest cost and low maintenance, but generally less impact-resistant; color runs through the material, so it hides scratches well. Adding insulated vinyl can improve energy performance for a higher price.
• Engineered wood: a wood-look appearance with better durability than natural wood, typically lighter and faster to install than fiber-cement, and usually mid-priced.
• Fiber-cement: very durable and well-suited to hail and UV exposure, with strong curb appeal, but heavier, more labor-intensive, and usually the highest installed cost.

Energy savings depend heavily on what is behind the siding, your existing insulation, and air-sealing, so siding alone is rarely a dramatic utility-bill change. If energy is a priority, talk through the wall assembly, not just the cladding.

A Note on Insurance and Hail Claims

Because hail is so common here, some Front Range siding replacements are tied to insurance claims rather than paid fully out of pocket. Whether storm damage is covered, and how much, depends entirely on your policy, your deductible, and your insurer's assessment. We are a contractor, not your insurance company or an attorney, so treat this as general information, not insurance or legal advice.

If you think you have storm damage, document it, review your policy, and talk to your carrier. A reputable contractor can inspect and explain what they see, but they should never promise to "get your claim approved" or offer to cover your deductible. Be cautious of anyone who does.

Getting an Accurate Number for Your Home

The ranges above are meant to help you budget and sanity-check bids, not replace a real quote. The price that matters is the one based on your actual square footage, your current siding, the trim and prep your house needs, and the access on your lot. That only comes from someone walking the home.

CR Custom Exteriors is a family-owned, licensed and insured exterior contractor based in Erie, Colorado, with more than 10 years of experience, Owens Corning roofing experience, and a 4.9-star rating across 150-plus Google reviews. If you'd like a clear, itemized estimate with no pressure, we're happy to take a look. Call us at (720) 583-5648 for a free estimate, and we'll walk you through your options and an honest range for your home.